• Check Product Safety Lawrenceville, Georgia 30044 USA Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affi liates in the U.S. Verify the Power Source from the On/Off Power Light Telephone: 770 236-1077 Upon completion of any service or repairs to this product, the service technician must and other countries. Connect the 12 VDC Power Supply plug to the wall power outlet. Use only the power adapter provided with this product. Access Point) must be accompanied by the Cisco ISB7005 Wireless Receiver (set-top).

AT&T U-verse VAP2500 Wireless Access Point Quick Start Guide Safety and Compliance WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN. AT&T U-verse VAP2500 Wireless Access Point Quick Start Guide Safety and Compliance WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN. Using the built-in Wi-Fi access point of the 2Wire Gateway is convenient for most subscribers. However, if you already have a newer 802.11n.

Connect the power plug to the power receptacle on the wireless access point.

• • • • • At&T's U-verse package combines cable, satellite dish, broadband and voice over Internet into a bundle. As with most technological advances, there are always a few bumps in the road before near perfection sets in. Most people who have high speed Internet and have wireless capabilities, use a modem and router. The AT&T U-verse 2Wire RG is an all-in-one modem/router/Wi-Fi access point, also known as a residential gateway. There are a lot of settings you can tweak if you access your U-verse residential gateway. You can modify the wireless settings by accessing the 2WIRE setup. This is the method tech support uses if you're experiencing problems with your U-verse service.

Step Locate your 2WIRE pass code that is located on the bottom of the RG. It is near the area on the barcode where your wireless network key is. Write the pass code down. Acer Driver Usb 3.0.

Then type the following address in the Web browser: 192.168.1.254/mdc. Step Once in the program, click the System Summary, then select the 'Home Network' tab. Step Navigate to the 'Status at a glance' area.

Various settings, such as your wireless encryption, key, Network Name and channel appear. The default setting for your wireless channel is located there as well.